WHERE ARE FORMULA FRAMES MADE?

In order to keep up with overwhelming demand over the past two years, our frames are now built in our own production facility in Taiwan
 

RETURNS

We will accept frames for return and refund only if the frame has NOT been assembled and comes back in the original packaging and is in good condition. There will be a 20% re-stocking fee on all returned items.

WHAT IS THE WARRANTY POLICY ON A FORMULA FRAME?

We are proud to stand behind our products 100% with a limited lifetime warranty. If your frame breaks or is defective due to our error, we will replace it for free, under certain guidelines (the limited part). Check our WARRANTY page to get the details.

WHERE IS THE SERIAL NUMBER LOCATED?

The serial number is stamped on the bottom of the bottom bracket shell. Look close, its under the powder coat!

WHAT LENGTH IS THE BOTTOM BRACKET SPINDLE I NEED FOR A FORMULA?

The short answer is: ASK YOUR CRANK MANUFACTURER.

There is a common misconception that different BMX frames need different spindle lengths. ALL BMX frames use a 68mm width bottom bracket shell (the tube where your bottom bracket threads into) and all chain lines on BMX rear hubs fall somewhere in the 40mm-43mm range. Our frames are designed to use a 43mm chain line, measured from center of bottom bracket to center of sprocket. So depending on how much offset your spider has relative to where your spindle bottoms out in the crank arm, your spindle length will vary. It is all dependent on which crank arms you employ. For a more detailed explanation please visit the LAB.

 
 
 
 
 
 
   
 
Copyright (c) 2010 Formula Bicycle Co.. all rights reserved.